Japanese
English
- 有料閲覧
- Abstract 文献概要
- 1ページ目 Look Inside
- 参考文献 Reference
要約 目的:3Dプリンターで作製したトーリックマーカーを使用した白内障手術の報告。対象と方法:トーリック眼内レンズを挿入して白内障手術を行った8例11眼を対象とした。症例ごとに乱視軸の部位を刻んだ輪状のトーリックマーカーを3Dプリンターで作製した。手術ではこのマーカーを使って眼内レンズの軸を合わせた。サージカルガイダンスTMでも軸合わせを行い,本方法とのずれを検討した。結果:手術1週間後の軸ずれは5.73±3.82°であり,サージカルガイダンスTMに従った場合に予想される軸ずれは,8.36±5.87°であった。両者の間に有意差はなかった。結論:3Dプリンターで作製したトーリックマーカーを使用した白内障手術の正確さは,サージカルガイダンズTMに従った場合とほぼ同じであった。
Abstract. Purpose:To report the outcome of cataract surgery with insertion of astigmatic intraocular lens using a toric marker produced by a 3D printer. Cases and Method:This study was made on 11 eyes of 8 patients who received cataract surgery with insertion of astigmatic intraocular lens. A ring-shaped axis marker, produced by a 3D printer, was used to indicate the astigmatic axis during surgery. The outcome was compared with the supposed one using Surgical GuidanceTM. Results:Deviation of astigmatic axis averaged 5.73±3.82 degrees one week after surgery. It averaged 8.36±5.87 degrees when Surgical GuidanceTM was used. There was no significant difference between the two values. Conclusion:Cataract surgery using a toric marker produced by a 3D printer showed same accuracy as when Surgical GuidanceTM was used.
Copyright © 2015, Igaku-Shoin Ltd. All rights reserved.